[ Prev ]   Page:  1   2   3   4   5   6   7   8   9   10   11   12   [ Next ]

PDF version for print
 

Types of finish

Access panels supplying to job site by bare finish, and factory bonded vinyl or HPL finish.

 
  1. Bare panel
    Bare panel installed by corner lock installation method, Floor coverings are installed at job site after completion of access floor installation. Commercial rate floor tiles such as carpet tile, vinyl, and rubber tile are standard floor coverings. Floor tiles are loose-laid, or bonded by releasable adhesives. Vinyl tiles are recommended anti-static, pure PVC wear layer no less than 0.7 mm, and total thickness no less than 4 mm.
  


bare panel
   

 
  1. Factory-bond finish access panel
    1. Vinyl tile access panel: 2 mm thick homogeneous vinyl tile, four sides sealed by vinyl trimmer as protection. 
       
    2. Conductive vinyl tile access panel: 2 mm or 3 mm thick homogenous conductive vinyl tile, four sides sealed by conductive vinyl trimmer as protection.
 


vinyl finish panel
   

 
    1. HPL finish:
      1.2 m thick HPL, four sides sealed by vinyl trimmers as protection.
  


HPL finish panel
     
  1. Perforated panel: for under-floor air distribution
    Factory bonded perforated access panel for under-floor air distribution at required air-flow ratio.
    Air-flow ratio: 20%, 35%, 40%
    Finishing: available in HPL and vinyl, four sides sealed by vinyl trimmers as protection.
    Concentrate load: 800, 1000, 1,250 LB
  


perforated panel
 

[ Prev ]   Page:  1   2   3   4   5   6   7   8   9   10   11   12   [ Next ]

PDF version for print

Copyright Netfloor, Inc. All Rights Reserved.